- Email: [email protected]
Forceful thin sensor
TOOLS & TECHNIQUES UPDATE
Grab frames fast
Ionized-PVD goes retro
For high quality imaging, DataCell’s Phoenix board
SKION’s new retrofit kit converts conventional magnetron sputter cathodes to a negative sputter ion
provides framegrabbing at a transfer rate of up to 528 Mb/s. Particularly suited to fluorescence microscopy, the frame rate and sensitivity can be adjusted for optimum images in specific conditions. Image quality is further enhanced by operating the light sensitive chips at 0°C to reduce noise and allowing
beam source for ionized physical vapor deposition (PVD). The retrofit can enhance thin film formation and generate advanced coatings for atomically smooth surfaces (<1 nm Ra), strong adhesion, atomic layer deposition, and room temperature indium tin oxide/ITO
On-chip binning can be manually set to increase the
(6 x 10 -4 ohm-cm, 90% transmittance). The retrofit kit can be installed at the shield of any size sputter
sensitivity and frame speed. The Phoenix framegrabber
cathode, including rectangular magnetron cathodes.
is also compatible with Hamamatsu’s latest, high-
Contact: www.skion.com
longer exposure times for low light-level imaging.
resolution 3-chip CCD camera, and supports both the 32-bit/33MHz and the new 64-bit/66MHz PCI buses. Contact: www.datacell.com
Samples for spectrophotometers A new sample preparation unit/autosampler from Hitachi High-Technologies Corporation is now available for use with the Z-5300 flame only and Z-5000 atomic absorption spectrophotometers. The SSC-400 can accommodate up to 80 15 ml sample tubes and up to eight 50 ml reagent vessels. Reagents can be added to the sample in volumes from 0.1-5 ml. Standards can be measured automatically and calibration curves produced. Samples can be diluted by a factor of 2-100 times and measured. The SSC-400 can also be used with the spectrophotometer’s automatic QC facility to test validity of calibration data and other parameters, ensuring reliability and accuracy of the analysis data. Contact: www.hsi-europe.com
Sniffing out helium Forceful thin sensor
44
MKS Instruments Inc. announces a portable, selfcontained mass spectrometer-based leak detector
Designing materials Supramolecular Organization and Materials Design edited by William Jones and Chintamani Rao demonstrates the importance of supramolecular chemistry and self-organization in the design and synthesis of novel organic, inorganic, and biomaterials. The bottom-up approach of supramolecular chemistry is looked at in the context of the synthesis of new materials and function-specific molecular devices. Published by Cambridge University Press (CUP), this book will be of interest to researchers and graduate students of chemistry, materials science, and physics who require a summary of the most recent developments in this field. ISBN: 0-521-66240-0 Publication: December 2001 Hardback, pp. 456 Price: $110/£70
Contact: http://uk.cambridge.org The promise of biomaterials Chitin could be the answer to a variety of needs in biomedicine. It possesses capabilities that make it suitable for use as a wound dressing, in bone substitutes, or as drug delivery carriers – properties which have evoked great enthusiasm. Chitin: Fulfilling a Biomaterials Promise, by Eugene Khor, places past promises in perspective, addresses present realities and limitations, and offers an insight into what is required for chitin, and its derivative chitosan, to fulfill its potential as a
Pressurex®, from Sensor Products Inc., is a tactile force
measuring just 4” x 15” x 10”. The PICO™ Series uses
indicating sensor film that monitors the force
an ion trap mass spectrometer and is a ‘sniffing’ style
distribution between two mating or impacting surfaces.
helium leak detector for use with pressurized objects.
The film is a large, thin sheet that instantaneously and
The detector weighs just 16 lbs and can detect leak
permanently changes color – the intensity of which is
rates as low as 1 x 10 -7 atm-cc/s from pressurized lines
proportional to the force applied. The precise
or enclosures and from vacuum chambers. The detector
pressure (kg/cm 2) can be determined using a color
has an integral vacuum system incorporating a
calibration chart. Assessing the compression magnitude
turbomolecular pump and backing scroll pump. The
and distribution between any two touching surfaces,
touch screen interface displays current and historical
this sensor is suitable for use in quality control (QC),
helium leak rate data and features include an adjustable
manufacture (e.g. of fuel cells and for the calibration of
audio signal, three-meter probe, and ‘zero’ feature that
machines and components) and in research applications.
compensates for background levels of helium.
biomaterial for the 21st century. ISBN: 0-080-44018-5 Publication: October 2001 Hardback, pp. 148 Price: $123/e113.45
Contact: www.sensorprod.com
Contact: www.mksinst.com
Contact: www.elsevier.com
February 2002
Grab frames fast
Ionized-PVD goes retro
For high quality imaging, DataCell’s Phoenix board
SKION’s new retrofit kit converts conventional magnetron sputter cathodes to a negative sputter ion
provides framegrabbing at a transfer rate of up to 528 Mb/s. Particularly suited to fluorescence microscopy, the frame rate and sensitivity can be adjusted for optimum images in specific conditions. Image quality is further enhanced by operating the light sensitive chips at 0°C to reduce noise and allowing
beam source for ionized physical vapor deposition (PVD). The retrofit can enhance thin film formation and generate advanced coatings for atomically smooth surfaces (<1 nm Ra), strong adhesion, atomic layer deposition, and room temperature indium tin oxide/ITO
On-chip binning can be manually set to increase the
(6 x 10 -4 ohm-cm, 90% transmittance). The retrofit kit can be installed at the shield of any size sputter
sensitivity and frame speed. The Phoenix framegrabber
cathode, including rectangular magnetron cathodes.
is also compatible with Hamamatsu’s latest, high-
Contact: www.skion.com
longer exposure times for low light-level imaging.
resolution 3-chip CCD camera, and supports both the 32-bit/33MHz and the new 64-bit/66MHz PCI buses. Contact: www.datacell.com
Samples for spectrophotometers A new sample preparation unit/autosampler from Hitachi High-Technologies Corporation is now available for use with the Z-5300 flame only and Z-5000 atomic absorption spectrophotometers. The SSC-400 can accommodate up to 80 15 ml sample tubes and up to eight 50 ml reagent vessels. Reagents can be added to the sample in volumes from 0.1-5 ml. Standards can be measured automatically and calibration curves produced. Samples can be diluted by a factor of 2-100 times and measured. The SSC-400 can also be used with the spectrophotometer’s automatic QC facility to test validity of calibration data and other parameters, ensuring reliability and accuracy of the analysis data. Contact: www.hsi-europe.com
Sniffing out helium Forceful thin sensor
44
MKS Instruments Inc. announces a portable, selfcontained mass spectrometer-based leak detector
Designing materials Supramolecular Organization and Materials Design edited by William Jones and Chintamani Rao demonstrates the importance of supramolecular chemistry and self-organization in the design and synthesis of novel organic, inorganic, and biomaterials. The bottom-up approach of supramolecular chemistry is looked at in the context of the synthesis of new materials and function-specific molecular devices. Published by Cambridge University Press (CUP), this book will be of interest to researchers and graduate students of chemistry, materials science, and physics who require a summary of the most recent developments in this field. ISBN: 0-521-66240-0 Publication: December 2001 Hardback, pp. 456 Price: $110/£70
Contact: http://uk.cambridge.org The promise of biomaterials Chitin could be the answer to a variety of needs in biomedicine. It possesses capabilities that make it suitable for use as a wound dressing, in bone substitutes, or as drug delivery carriers – properties which have evoked great enthusiasm. Chitin: Fulfilling a Biomaterials Promise, by Eugene Khor, places past promises in perspective, addresses present realities and limitations, and offers an insight into what is required for chitin, and its derivative chitosan, to fulfill its potential as a
Pressurex®, from Sensor Products Inc., is a tactile force
measuring just 4” x 15” x 10”. The PICO™ Series uses
indicating sensor film that monitors the force
an ion trap mass spectrometer and is a ‘sniffing’ style
distribution between two mating or impacting surfaces.
helium leak detector for use with pressurized objects.
The film is a large, thin sheet that instantaneously and
The detector weighs just 16 lbs and can detect leak
permanently changes color – the intensity of which is
rates as low as 1 x 10 -7 atm-cc/s from pressurized lines
proportional to the force applied. The precise
or enclosures and from vacuum chambers. The detector
pressure (kg/cm 2) can be determined using a color
has an integral vacuum system incorporating a
calibration chart. Assessing the compression magnitude
turbomolecular pump and backing scroll pump. The
and distribution between any two touching surfaces,
touch screen interface displays current and historical
this sensor is suitable for use in quality control (QC),
helium leak rate data and features include an adjustable
manufacture (e.g. of fuel cells and for the calibration of
audio signal, three-meter probe, and ‘zero’ feature that
machines and components) and in research applications.
compensates for background levels of helium.
biomaterial for the 21st century. ISBN: 0-080-44018-5 Publication: October 2001 Hardback, pp. 148 Price: $123/e113.45
Contact: www.sensorprod.com
Contact: www.mksinst.com
Contact: www.elsevier.com
February 2002