Holocene displacement along branch and secondary faults in the San Andreas fault zone, southern California

Holocene displacement along branch and secondary faults in the San Andreas fault zone, southern California

376 ~ec~ono~~y~ics, 52 (1979) 376-377 0 Elsevier Scientific Publishing Company, Amsterdam - Printed in The Netherlands HOLOCENE DISPLACEMENT ALONG B...

137KB Sizes 0 Downloads 43 Views

376

~ec~ono~~y~ics, 52 (1979) 376-377 0 Elsevier Scientific Publishing Company, Amsterdam - Printed in The Netherlands

HOLOCENE DISPLACEMENT ALONG BRANCH AND SECONDARY FAULTS IN THE SAN ANDREAS FAULT ZONE, SOUTHERN CALIFORNIA *

JAMES E. KAHLE, ALLAN G. BARROWS and DAVID J. BEEBY California Division of Mines and Geology, Los Angeles, Calif. 90012

(U.S.A.)

(Accepted for publication May 22,1978)

ABSTRACT

Detailed geologic mapping of the San Andreas fault zone in Los Angeles County since 1972 has revealed evidence for diverse histories of displacement on branch and secondary faults near Palmdale. The main trace of the San Andreas fault is well defined by a variety of physiographic features. The geologic record supports the concept of many kilometers of lateral displacement on the main trace and on some secondary faults, especially when dealing with pre-Quaternary rocks. However, the distribution of upper Pleistocene rocks along branch and secondary faults suggests a strong vertical component of displacement and, in many locations, Holocene displacement appears to be primarily vertical. The most recent movement on many secondary and some branch faults has been either high-angle (reverse and normal) or thrust. This is in contrast to the abundant evidence for lateral movement seen along the main San Andreas fault. We suggest that this change in the sense of displacement is more common than has been previously recognized. The branch and secondary faults described here have geomorphic features along them that are as fresh as similar features visible along the most recent trace of the San Andreas fault. From this we infer that surface rupture occurred on these faults in 1857, as it did on the main San Andreas fault. Branch faults commonly form “Riedel’” and “thrust” shear configurations adjacent to the main San Andreas fault and affect a zone less than a few hundred meters wide. Holocene and upper Pleistocene deposits have been repeatedly offset along faults that also separate contrasting older rocks, Secondary faults are located up to 1500 m on either side of the San Andreas fault and trend subparallel to it. Moreover, our mapping indicates that * Based on work sponsored in part by U.S. Geological Survey Grants Nos. 14-08-0001-G74, 133, 263 or 344, and in cooperation with the County of Los Angeles, Department of County Engineer. Mapping done by Drew Smith was very helpful in the early phases of this work.

some portions of these secondary faults appear to have been “inactive” throughout much of Quatemary time, even though Holocene and upper Pleistocene deposits have been repeatedly offset along other parts of these same faults. For example, near 37th Street E. and Barrel Springs Road, a limited stretch of the Nadeau fault has a very fresh normal scarp, in one place as much as 3 m high, which breaks upper Pleistocene or Holocene deposits. This scarp has two bevelled surfaces, the upper surface sloping significantly less than the lower, suggesting at least two periods of recent movement. Other exposures along this fault show undisturbed Quatemary deposits overlying the fault. The Cemetery and Little Rock faults also exhibit selected reactivation of isolated segments separated by “inactive” stretches. Activity on branch and secondary faults, as outlined above, is presumed to be the result of sympathetic movement on limited segments of older faults in response to major movement on the San Andreas fault. The recognition that Holocene activity is possible on faults where much of the evidence suggests prolonged inactivity emphasizes the need for regional, as well as detailed site studies to evaluate adequately the hazard of any fault trace in a major fault zone. Similar problems may be encountered when geodetic or other studies, which depend on stable sites, are conducted in the vicinity of major faults.